Good Wooden Cutting Board Countertop

Published On January 10, 2019 | By maria | Countertops

A good wooden cutting board countertop is essential in any kitchen. And that is precisely the theme that we propose, make a kitchen table with lath wood to which we will make a slot in which the liquids will be collected, which will facilitate its subsequent cleaning. The coto wood, which we are going to use to make this kitchen table, has a medium hardness, and is very suitable for the use that we are going to give it. We mark two 3 cm wide pieces on the slatted board with which we will make the top and bottom stops of the kitchen table.

Built In Cutting Board Countertop

Built In Cutting Board Countertop

With the jig saw provided with a cutting guide placed at 3 cm, which will allow us to make the cut straight and parallel to the line and wood blade, cut the two pieces. After cutting, we review the edges of the slats and the cutting board countertop with a sheet of sandpaper. Mark the position of the slats in the table, as well as three fixing points in each of them, 1.5 cm from the edges. We make the holes with the drill and a wood drill of the same diameter as the pipes and a drill stop placed at 1.5 cm depth.

14 Photos Gallery of: Good Wooden Cutting Board Countertop

Image of: Wood Cutting Board Countertop

Image of: Plastic Cutting Board Countertop

Image of: Kitchen Cutting Board Countertop

Image of: Drop In Cutting Board For Countertop

Image of: Cutting Board Countertops

Image of: Cutting Board Countertops Plastic

Image of: Cutting Board Countertops Photos

Image of: Cutting Board Countertop Material

Image of: Cutting Board Countertop Insert

Image of: Cutting Board Countertop Ikea

Image of: Cutting Board Countertop Food

Image of: Cutting Board Countertop Diy

Image of: Butcher Block Cutting Board Countertop

Image of: Built In Cutting Board Countertop

Then, we put the markers in the holes we have made in the table. We present the ribbons on them and press. The points to be drilled will be marked. The next step will be to drill the holes at the points marked on the slats. We apply mounting adhesive to the holes in the upper part of the cutting board countertop, insert the pipes with a nylon hammer and fit the upper strip. We put some clamps until the adhesive hardens. Round off the corners of the front of the board with a rasp. Place a wooden template in the center of the board with strips of double-sided adhesive tape.

Comments are closed.